Danylova, LiudmylaAL, Anthony Kassis2023-11-132023-11-132023Anthony AL Kassis. Technological preparation of a manufacturing process to produce a part “bearing housing” : diploma project for a bachelor's degree : 131 Applied mechanics / Anthony AL Kassis. – Kyiv, 2023. – 64 с.https://ela.kpi.ua/handle/123456789/62126This work primarily focuses on the technological preparation required for the manufacturing process involved in producing a part bearing housing. The thesis consists of 64 A4-sized sheets and draws upon a total of 20 literature sources, including reference books and scientific papers. Chapter 5 of this thesis extensively discusses the issue of burr formation during drilling. The mechanism behind burr formation is thoroughly examined, followed by an exploration of methods to prevent and reduce burrs by altering the drill's geometry. The overall objective of this work is to provide a comprehensive understanding of the technological aspects involved in preparing the manufacturing process for producing a part bearing housing. It encompasses critical elements such as process planning, fixture design, economic analysis, safety measures, and addressing the challenge of burr formation.64 с.enBachelor Thesis621