Manufacturing Process Planning for the Part "Support"
Вантажиться...
Дата
2023
Науковий керівник
Назва журналу
Номер ISSN
Назва тому
Видавець
Igor Sikorsky Kyiv Polytechnic Institute
Анотація
The bachelor's thesis on the topic "Process Planning for Manufacturing of the «Support» part. It consists of 61 sheets of A4 format and contains 59 illustrations, and 5 tables.
The objective of this thesis is the development of the manufacturing process for the "Support" part. In the first chapter, a simulation of the casting process was performed. In the second chapter, the sequence of manufacturing operation was developed. Within this task CNC machines, cutting tools, and cutting conditions were selected. For the two specific manufacturing operations the fixtures were selected, and corresponding setups were developed. Economic calculations were performed for the first manufacturing operation.
The graphic part consists of 6 sheets of Al format, as follows:
1. Cast iron : Simulation
2. Drawings and 3D models of the "Support" part and blank
3. Manufacturing operation presentation
4. Fixture setup for the 1st manufacturing operation
5. Fixture setup for the last manufacturing operation
6. Results of CNC code development
Опис
Ключові слова
Support
Бібліографічний опис
Ahmed Mahdi Abdulla Ebrahim Ali Alabaidat. Manufacturing Process Planning for the Part "Support" : diploma project for a bachelor's degree : 131 Applied mechanics / Ahmed Mahdi Abdulla Ebrahim Ali Alabaidat. – Kyiv, 2023. – 61 с.