Process Planning for Manufacturing of the "Housing" Part
Вантажиться...
Дата
2024
Автори
Науковий керівник
Назва журналу
Номер ISSN
Назва тому
Видавець
Igor Sikorsky Kyiv Polytechnic Institute
Анотація
The bachelor's thesis on the topic " Process Planning for Manufacturing of the "Housing" Part contains 80 sheet A4 format explanatory text illustrations and tables. 14 references covering a wide range of areas including Mechanical engineering handbooks, articals about the different moulding technologies, websites and catalogue guidance.
The objective of this thesis is to develop a manufacturing process for the “Hous ing”part. A sequence of manufacturing operations was developed. The work includes the selection of casting operation,design of manufacturing proscess selection of machining center, cutting tools, cutting dates, and costing estimations, among other things. For one manufacturing operations, fixtures were developed, and the corresponding setups are presented in the graphical section of the work.
Economic analysis was conducted for the initial manufacturing operation.
Some computer software is utilized: Siemens NX and Solidworks for 3D modeling of workpiece and assemble and install of fixture. NX CAM to develop the machining toolpaths . CAE system to estimate the tool defelction.
The graphic part consists of 6 sheets of A1 format, as follows:
1. Tool deflection during finish boring process.
2. Drawing of 3D model and a blank
3. Manufacturing operation presentation
4. Drawing of the workpiece and clamping device
5. Results of NC-program development
Опис
Ключові слова
Housing
Бібліографічний опис
Han Peiran. Process Planning for Manufacturing of the "Housing" Part : diploma project for a bachelor's degree : 131 Applied mechanics / Han Peiran. – Kyiv, 2024. – 85 p.